MCP2562-E/P, CAN шина, приемопередатчик, CAN, LIN, 1, 1, 4.5 В, 5.5 В, DIP

The MCP2562-E/P is a second generation high-speed CAN Transceiver serves as an interface between a CAN protocol controller and the physical two-wire CAN bus. The device meets the automotive requirements for high-speed (1Mb/s), low quiescent current, electromagnetic compatibility (EMC) and electrostatic discharge (ESD). The device family members are MCP2561 with SPLIT pin and MCP2562 with VIO pin. It serves as the interface between a CAN protocol controller and the physical bus. The MCP2562 device provides differential transmit and receive capability for the CAN protocol controller and is fully compatible with the ISO-11898-2 and ISO-11898-5 standards. It will operate at speeds of up to 1Mb/s. Typically, each node in a CAN system must have a device to convert the digital signals generated by a CAN controller to signals suitable for transmission over the bus cabling (differential output).

• AEC-Q100 Grade 0
• 5µA Typical very low standby current
• VIO supply pin to interface directly to CAN controllers and microcontrollers
• SPLIT output pin to stabilize common mode in biased split termination schemes
• CAN bus pins are disconnected when device is unpowered
• Detection of ground fault - Permanent dominant detection on TXD
• Power-on reset and voltage brown-out protection on VDD pin
• Protection against damage due to short-circuit conditions (positive or negative battery voltage)
• Protection against high-voltage transients in automotive environments
• Automatic thermal shutdown protection
• Suitable for 12 and 24V systems
• Up to 112 nodes can be connected
• Meets or exceeds stringent automotive design requirements
• High-noise immunity due to differential bus implementation
• High electrostatic discharge (ESD) protection on CANH and CANL

Полупроводники - Микросхемы\Драйверы и Интерфейсы\Устройства CAN Шины

Технические параметры