MCP2561-E/P, CAN шина, приемопередатчик, CAN, LIN, 1, 1, 4.5 В, 5.5 В, DIP
- Производитель
- Microchip
Цена 91 руб. за 1 шт
Количество- Полное описание
The MCP2561-E/P is a high-speed CAN Transceiver serves as the interface between a CAN protocol controller and the physical bus. The MCP2561 provides differential transmit and receive capability for the CAN protocol controller and is fully compatible with the ISO-11898-5 standard. It will operate at speeds of up to 1Mb/s. Typically, each node in a CAN system must have a device to convert the digital signals generated by a CAN controller to signals suitable for transmission over the bus cabling (differential output). It also provides a buffer between the CAN controller and the high-voltage spikes that can be generated on the CAN bus by outside sources. It has under-voltage detection on both supply pins: VDD and VIO. Typical under-voltage thresholds are 1.2V for VIO and 4V for VDD. When the device is powered on, CANH and CANL remain in a high-impedance state until both VDD and VIO exceed their under-voltage levels.
• Supports 1Mb/s Operation
• Implements ISO-11898-5 standard physical layer requirements
• SPLIT Output pin to stabilize common mode in biased split termination schemes
• CAN bus pins are disconnected when device is unpowered
• An unpowered node or brown-out event will not load the CAN bus
• Permanent dominant detection on TXD
• Permanent dominant detection on bus
• Protection against damage due to short-circuit conditions
• Protection against high-voltage transients in automotive environments
• Automatic thermal shutdown protection
Полупроводники - Микросхемы\Драйверы и Интерфейсы\Устройства CAN Шины
Технические параметры
Минимальная Рабочая Температура | -40 C |
Максимальная Рабочая Температура | 125 C |
Максимальное Напряжение Питания | 5.5В |
Минимальное Напряжение Питания | 4.5В |
Количество Выводов | 8вывод(-ов) |
Тип Интерфейса ИС | CAN, LIN |
Стиль Корпуса Интерфейса | dip |
Количество Буферов TX | 1 |
Количество RX Буферов | 1 |
Максимальная рабочая температура | +150 C |
Поддерживаемый стандарт | IEC 61000-4-2 |
Длина | 10.2мм |
Минимальное рабочее напряжение питания | 4,5 В |
Производитель | Микрокристалл |
Тип корпуса | PDIP |
Тип монтажа | Монтаж на плату в отверстия |
Минимальная рабочая температура | -40 C |
Максимальная скорость передачи данных | 1Мбит/с |
Ширина | 7.1мм |
Максимальный ток питания | 70 mA |
Режим выключения питания | Ожидание |
Высота | 5мм |
Максимальное рабочее напряжение питания | 5.5 V |
Число контактов | 8 |
Размеры | 10.2 x 7.1 x 5мм |
Количество приемопередатчиков | 1 |
Вес, г | 0.454 |