FT4232HQ-REEL, Интерфейсные мосты, USB в UART, MPSSE, 1.62 В, 1.98 В, QFN, 64 вывод(-ов), -40 C

The FT4232HQ-R is a 5th generation USB 2.0 High-speed (480Mbps) to UART IC. It has the capability of being configured in a variety of industry standard serial or parallel interfaces. The IC features 4 UARTs. Two of these have an option to independently configure an MPSSE engine, this allows the IC to operate as two UART/bit-bang ports plus two MPSSE engines used to emulate JTAG, SPI, I?C, bit-bang or other synchronous serial modes.

• Single chip USB to quad serial ports with a variety of configurations
• Entire USB protocol handled on chip, no USB specific firmware programming required
• USB 2.0 high-speed (480Mbps) and full-speed (12Mbps) compatible
• Two multi-protocol synchronous serial engine (MPSSE) on channel A and channel B
• Independent baud rate generators
• RS232/RS422/RS485 UART transfer data rate up to 12Mbaud (RS232 Data Rate Limited)
• FTDI's royalty-free virtual com port (VCP) and direct (D2XX) drivers
• Optional traffic TX/RX indicators can be added with LEDs and an external 74HC595 shift register
• Adjustable receive buffer timeout
• Support for USB suspend and resume conditions via PWREN#, SUSPEND# and RI# pins
• Highly integrated design
• FTDI FT232B style, asynchronous serial UART interface option
• Fully assisted hardware or X-On/X-Off software handshaking
• UART interface supports 7/8-bit data, 1/2 stop bits and odd/even/mark/space/no parity
• Auto-transmit enable control for RS485 serial applications using TXDEN pin
• Operational configuration mode and USB description strings configurable in external EEPROM over USB
• Low operating and USB suspend current
• Configurable I/O drive strength (4, 8, 12 or 16mA) and slew rate
• Supports bus powered, self powered and high-power bus powered USB configurations
• UHCI/OHCI/EHCI host controller compatible

Полупроводники - Микросхемы\Драйверы и Интерфейсы\Интерфейсные Мосты

Технические параметры