TPIC1021D

The TPIC1021D is a Local Interconnect Network Physical Interface integrates the serial transceiver with wake up and protection features. The LIN bus is a single wire, bi-directional bus typically used for low-speed in-vehicle networks using baud rates between 2.4 and 20kbps. The LIN bus has two logical values: the dominant state (voltage near ground) represents a logic 0 and the recessive state (voltage near battery) and represents logic 1. In the recessive state the LIN bus is pulled high by the TPIC1021's internal pull-up resistor (30kR) and series diode, so no external pullup components are required for slave applications. Master applications require an external pullup resistor (1R) plus a series diode. The LIN protocol output data stream on the TXD pin is converted by the TPIC1021 into the LIN bus signal through a current limited, wave-shaping low-side driver with control as outlined by the LIN Physical Layer Specification Revision 2.0.

• LIN physical layer specification revision 2.0
• Low current consumption in low power mode
• Wake-up available from LIN bus, wake-up input
• Dominant state timeout protection on TXD pin
• Wake-up request on RXD pin
• Control of external voltage regulator (INH pin)
• Integrated pull-up resistor and series diode for LIN slave applications
• Low EME and high EMI
• Bus terminal short-circuit protected for short-to-battery or short-to-ground
• Thermally protected
• Ground disconnection failsafe at system level
• Ground shift operation at system level
• Unpowered node does not disturb the network
• Green product and no Sb/Br

Полупроводники - Микросхемы\Драйверы и Интерфейсы\LIN Приемопередатчики

Технические параметры